The entry selected in the list is ignored, and has no effect. This has no effect on the Static Routing Table.Īdd a new entry to the Static Routing table, using the data shown in the "Properties" area on screen. Metric - The number of "hops" (routers) to pass through.Interface - Choose the desired option. Which the Broadband Router must use to communicate with the destination above. Gateway IP Address - The IP Address of the Gateway or Router.Network Mask - The Network Mask for the remote LAN segment.įor class "C" networks, the default mask is 255.255.255.0.For standard class "C" LANs, the network address is the first 3 fields of the Destination IP Address. Destination IP Address - The network address of the remote LAN segment.Change any the properties as required, then click the "Update" button to save the changes to the selected entry.The "Properties" area shows details of the selected item in the list.This list shows all entries in the Routing Table. RIP-1 is probably adequate for most networks, unless you have an unusual network setup. (It recognizes both formats when receiving.) By default, this is set for RIP-1. This controls the format and the broadcasting method of the RIP packets that the gateway sends. In order to use the static routing table. You need to understand the principles of routing This screen is only required if your LAN has other Routers or Gateways.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |